Selective permeability of the cell membrane

The cell membrane is there to define what’s on the inside of a cell - the intracellular space - versus what’s on the outside of a cell - the extracellular space.

And it helps regulate what comes in or out of the cell, which is called selective permeability.

Movement across the cell membrane can occur by passive transport, which requires no energy, and active transport, which requires energy in the form of adenosine triphosphate, or ATP for short.

There are three types of passive transport - diffusion, facilitated diffusion, and osmosis.

Diffusion helps small, non-polar molecules, like oxygen and carbon dioxide, move across the membrane, from an area of high concentration to low concentration.

The difference in concentrations is known as the concentration gradient, and diffusion can occur as long as this gradient exists, and stops once there are equal concentrations of the molecule on both sides.

Facilitated diffusion helps larger molecules and polar molecules move across the membrane.

Facilitated diffusion uses transport proteins like channels and carrier proteins.

Channels are not very specific, and they can open or close to allow water and small polar molecules, like ions, that are dissolved in it to pass through.

These channels open in response to certain stimuli - for example, the voltage gated calcium channels respond when the electrical charges on the two sides of the cell membrane change.

Normally, there are more negative ions inside the cell than outside, so the inside of the cell membrane is negatively charged, and the outside is positively charged.

When positive ions make their way inside the cell through one form of transport or another, the cell starts to depolarize gradually - so step by step, the membrane becomes more positive on the inside, and more negative on the outside.

This change in the distribution of electrical charges makes the voltage gated calcium channels open and allow water, a lot of calcium ions, and a few sodium ions inside the cell.

When the entire membrane is depolarized, the channels close back up and inflow stops.

In contrast, carrier proteins are very specific - they have special binding sites that only allow certain molecules to bind to them, and they also have gates at both ends, which open sequentially.

An example of a carrier protein is the glucose transporter protein called GLUT4.

By default, the transporter is open to the outside, waiting for a glucose molecule to float by.

When a glucose molecule binds to a special site within the transporter, the outer gate closes, and the inner gate opens.