Pelvis and hip radiography: Rad Tech

Pelvis and hip radiography evaluates bones, joints, and surrounding anatomy. It's utilized when a patient has acute non-traumatic pain, limited motion, chronic symptoms, or needs follow-up after treatment.
Standardized projections demonstrate alignment and changes related to developmental, inflammatory, degenerative, and other conditions.
Imaging can also support surgical planning and assess orthopedic hardware or a prosthesis after surgery. To make these assessments reliable, technologists use standard projections and consistent anatomic landmarks.
The AP pelvis projection provides an overview of the pelvic girdle, both hip joints, and proximal femora. It's commonly used to assess alignment, symmetry, degenerative joint disease, and developmental conditions.
When movement is safe, internally rotate the feet and lower limbs 15 to 20 degrees. This brings the femoral necks more parallel to the image receptor, placing the greater trochanters in profile.
This also prevents foreshortening, which makes the femoral necks appear shorter on the image than they actually are. Do not force this rotation when fracture or dislocation is suspected.
Next, the lateral hip projection provides a focused view of one hip, including the femoral head and neck, acetabulum, the lesser trochanter in profile, and the proximal femur.
The technique depends on the clinical situation. A modified cleaves or frog leg position may be used for a non-traumatic exam when the patient can safely flex and abduct the hip.
For a bilateral examination, the hips and knees are flexed, the femera are abducted equally, and the feet are brought together.
This demonstrates both the femoral heads and necks, acetabula, and trochanteric regions. If only one hip is of interest, or if the patient can position both legs equally, the patient will abduct the affected hip and knee and draw the affected foot upward toward the opposite knee.
If fracture or dislocation is suspected, use a horizontal beam axiolateral projection to minimize movement of the affected limb.
Choosing the projection is only part of the exam, positioning must also be safe and tolerable. Before moving the patient, assess pain, mobility, and the ability to hold the required position.
A well-supported patient is more likely to remain still, reducing motion and a repeat exposure. So use supports as needed, but don't let them rotate the pelvis or alter the required alignment.
If pain or limited mobility prevents routine positioning, do not force movement. If fracture or dislocation is suspected, image the affected limb as presented.
Adapt the exam according to department protocol, communicate the limitation to the radiologist, and document the change.
Once the image is acquired, confirm that the required anatomy is included, and that the bony relationships show correct positioning.
Errors from rotation or motion are often caused by pain, limited mobility, and difficulty holding still. On the AP pelvis, the iliac wings, obterator foramina, and ischial spines should appear symmetric.
The image should include the pelvic girdle, L5, sacrum, and coccyx, both hip joints, femoral heads and necks, greater and lesser trochanters, and proximal femera.
The femoral necks should be in profile with little foreshortening. Lateral image criteria depend on the selected projection.
On an axiolateral image, include the femoral head and neck, acetabulum, trochanteric region, and proximal femur. Only the distal portion of the femoral neck should overlap the greater trochanter.
On a modified cleaves image, greater trochanter overlap and some femoral neck foreshortening are expected. In all views, sharp trabecular markings and bony margins indicate adequate detail without motion.
All right, as a quick recap. Pelvis and hip radiography evaluates alignment and anatomy in patients with acute non-traumatic symptoms and chronic conditions.
The AP pelvis projection shows both hip joints and proximal femora, and helps assess symmetry and alignment. A lateral projection adds a second perspective, but the method must match the clinical situation.
Frog-like positioning is used for non-traumatic exams, while a horizontal beam axiolateral minimizes movement if fracture or dislocation is suspected.
The modified cleaves projection compares the hip in selected non-traumatic cases. Throughout the exam, careful positioning, patient comfort, and image evaluation help produce diagnostic quality images while limiting motion and repeat exposures.